• Register
  • Login
  • looking for something?

    117 x All Datasheet

    Browse through a total of 117 Download all transistors datasheets, catalogue, electronic components specification.

    2N2222   2N3094   BD139   L293D   LM311   LM317   LM324   LM339   LM358   LM386   LM3914   LM393   LM741   MAX232   TDA2030   TL082   555   4017   7400   7447   7805  

    Maxim MAX9910 Datasheet The MAX9910 datasheet specifies that this amplifier is unity-gain stable for loads up to 30pF. However, the capacitive load can be increased to 250pF when the amplifier is configured for a minimum gain of 10V/V. Applications that require greater capacitive-drive capability should use an isolation resistor between the output...
    74HC595 Datasheet The 74HC595 datasheet specifies that this IC is a 8-stage serial shift registers with a storage register and 3-state outputs. The registers have separate clocks. contain an 8-bit serial-in, parallel-out shift register that feeds an 8-bit D-type storage register. Data is shifted on the positive-going transitions of the shift...
    4001 Datasheet The HEF4001B is a quad 2-input NOR gate. The outputs are fully buffered for the highest noise immunity and pattern insensitivity to output impedance. It operates over a recommended VDD power supply range of 3 V to 15 V referenced to VSS (usually ground). Unused inputs must be connected to VDD, VSS, or another input. HEF4001B...
    4015 Datasheet The 4015 datasheet specifies that the IC contains two identical, 4-stage, serial-input/parallel-output registers with independent “Data”, “Clock”, and “Reset” inputs. The logic level present at the input of each stage is transferred to the output of that stage at each positive-going clock...
    74147 Datasheet 74147 datasheet specifiest that this IC is a TTL encoder feature priority decoding of the inputs to ensure that only the highest-order data line is encoded. The ’147 and ’LS147 devices encode nine data lines to four-line (8-4-2-1) BCD. The implied decimal zero condition requires no input condition, as zero is encoded when all...
    4511 Datasheet The 4511 datasheet specifies that this IC is a BCD to 7-segment latch/decoder/driver with four address inputs (DA to DD), an active LOW latch enable input (EL), an active LOW ripple blanking input (BI), an active LOW lamp test input (LT), and seven active HIGH NPN bipolar transistor segment outputs. HEF4511B datasheet...
    IRFZ44 Datasheet According to the IRFZ44 datasheet this is a third generation Power MOSFET that provide the best combination of fast switching, ruggedized device design, low on-resistance and cost-effectiveness. The TO-220AB package is universially preferred for commercial-industrial applications at power dissipation levels to approximately 50...
    4538 Datasheet The 4538 datasheet specifies that this IC is a dual, precision monostable multivibrator with independent trigger and reset controls. The device is retriggerable and resettable, and the control inputs are internally latched. Two trigger inputs are provided to allow either rising or falling edge triggering. The reset inputs are...
    7493 Datasheet The 7490 datasheet specifies that this counter contains four master-slave flip-flops and additional gating to provide a divide-by-two counter and a three-stage binary counter for which the count cycle length is divide-by-eight for the 7493A. All of these counters have a gated zero reset and the 7490A also has gated set-to-nine...
    556 Datasheet The 556 datasheet specifies that is dual timing circuit is a highly stable controller capable of producing accurate time delays or oscillation. The 556 is a dual 555. Timing is provided by an external resistor and capacitor for each timing function. The timers operate independently of each other sharing only VCC and ground....
    looking for something?